Derived from natural, sustainable ingredients. suitable for Formwork, Precast, Tilt Panel Concrete Release Agent
Features:
- Concentrate (mix with water)
- Low suction between panels
- Resists rain wash off
- Non evaporative
- Lubricates & protects fittings
Contents:
Lanolin (a natural product), blended with an evaporative carrier & surfactant. Mixes with water.
Usage:
- For use on form surfaces including steel, timber, plywood, PVC, rubber, polypropylene, plastic & fiberglass
- Safe for environmentally sensitive areas and waterways
- Protection of machinery and equipment from concrete overspray
Concrete (mix @ 1:6 parts water)
- Formwork Release Agent
- Tilt Panel Bond Breaker
- Precast Mould Oil
Scaffolding (mix @ 1:4 parts water)
- Lubricant for jacks & fittings
- Spatter protection for tubes, jack, fittings and equipment
- Storage & transport:
- This product is classified as non-Dangerous Goods
- Keep in cool, dry, well ventilated place
- Keep out of reach of children
- Shelf life - virtually indefinite if kept sealed in reasonable conditions
- Once mixed with water, use within 2 days
Code |
Item |
Pack |
1609 |
Lanotec Release Agent 2.9L |
2.9L |
2985 |
Lanotec Release Agent 5.0L |
5.0L |
2986 |
Lanotec Release Agent 20L |
20L |
Application:
Apply a fine even coat with quality sprayer and flush sprayer with water only
Preparation:
- Shake or stir Lanotec Release Agent concentrate to consistency before mixing with water.
- Add concentrate to container then add water to achieve your desired dilution rate.
- High quality sprayer recommended (Chapin brand or similar).
- For best results apply to a clean dry surface.
Tilt Panel
- When using as a bond breaker, apply to the top of cured panel in 2 even diagonal opposing coats. In extreme heat, the panels can be sprayed with water before Lanotec Release Agent is applied, this reduces the amount of Release Agent absorbed by the cured panel
- If it rains after application, feel for waxy surface and judge if further application is required
Formwork
- Continued use on formwork leaves surface clean after stripping; no cleaning required between pours, simply spray, pour, strip and repeat
- For best results, apply to the horizontal before erection (steel & aluminium) where practical
Precast
- Non staining for coloured concrete
- Can be applied after setting polystyrene block outs (does not affect polystyrene)
- If mopping the finish, use a new clean mop pre soaked in Lanotec Release Agent
- Safe for fibreglass, PVC, polypropylene and rubber moulds
- High performance for bullnose moulds
Coatings:
- Lanotec Release Agent degrades in the curing process of concrete
- If used to manufacturer specifications, chemical cleaning of the concrete is not required before applying a coating system. High pressure water blast is all that is required for best results
- Adhesion testing as per AS 1580.408 indicates that Lanotec Release Agent did not cause adhesion failure of the coating systems at the coating/concrete interface of coating systems to the cured concrete.
Tech Data Sheet
Tech Data Sheet
Safety Data Sheet
Safety Data Sheet
Chemical |
Application |
Release Agent and Bond Breaker |